Australia Bongs

How to clean your glass bongs Australia

It’s no secret that glass bongs in Australia can get incredibly dirty. However, many people avoid cleaning them partly out of laziness and partly because they don’t know how to. Although the process may sound difficult and time consuming, it is actually really simple. Keep reading to find out how to clean your glass bong in Australia.

Step 1: Empty your smoking device

It may sound simple, but the first thing you need to do in order to clean your glass bong in Australia is empty it. It will be impossible to properly clean your smoking device without first tipping out the dirty water.

Step 2: Remove all parts

Another simple, but essential part of cleaning your smoking device is taking it apart. It will be much easier to clean your pipe if it is in separate pieces, rather than assembled. So, separate any movable and removable parts of the device.

Step 3: Rinse in hot water

Once your glass bong in Australia is empty and has been taken apart, you can begin to actually clean it. The first thing you should consider doing is rinsing it with hot water.

Hot water is an excellent and easy way of removing any excess surface resin that has built up over time. The hotter the water, the more effective this will be. So consider buying some rubber washing up gloves to prevent you from burning your hands!

Step 4: Put lose parts in bags or containers

Any excess parts that you took off of your glass bong in Australia will also need to be cleaned. This can be tricky if the pieces are small. But there is a simple way of getting all these parts clean.

Instead of the fiddly job of washing each part by hand, instead put each section in its own bag or container. Add hot or warm water to these containers along with a cleaning solution.

If you aren’t sure what cleaning solutions to use, there are a few good options:

  • Washing up liquid
  • Rubbing alcohol
  • Salt
  • Vinegar
  • Lemon juice

Step 5: Shake

Once you have each part in its own container of cleaning solution, you will need to find a way to make sure it gets in all the little crevices.

A simple way of doing this is just by shaking the container. But first, make sure that no water can seep out, or you may find yourself covered in it.

The aim is to move the cleaning solution over the entire part and ensure that it begins to break down any dirt and grime that has accumulated over time. For this to be effective, you will probably want to shake the solution for at least five minutes.

Parts that are covered in stubborn grime may need to be left to soak in the cleaning solution. So, leave these for about ten minutes and come back to them later. After they have soaked, you can shake again to remove the last of the residue.

Step 6: Put cleaning solution in your smoking device

The same cleaning solution you used for the small parts of your glass bong in Australia can be used on the main part of the pipe. Remember that you will need a larger amount of solution for this as it is a larger part. However, remember to keep the liquid concentrated with cleaning solution so that it is strong enough to clean any tough residue.

Step 7: Cover the holes

Once you have tipped the cleaning solution into your smoking device, cover all holes to prevent it from seeping out. Although you may not have lids or items that fit these holes, you can plug them with items you already have in your house, such as:

  • Hand towels
  • Old t-shirts
  • Flannels
  • Cling film
  • Cotton balls

Step 8: Shake

Once all holes in your smoking device are sealed, you can begin to shake your pipe to allow the cleaning solution to reach all areas of it.

Continue shaking until all the residue has come lose from the surface of your glass bong in Australia.

Step 9: Rinse with warm water

After cleaning your glass bong in Australia with a cleaning solution, you will want to remove any remaining grime and product. The best way of doing this is simply by rinsing each part of your smoking device in hot water.

 

Please Login to Comment.